水性丙烯酸面漆的用途和使用说明

Storageand Handling 贮存与管理

Storage 贮存 dry and cool conditions 贮存于阴凉干燥处Pack size 包装规格 20Kg in 20 liter container 20公斤装于20公升容器Flash Point 闪点＞65℃

Specific Gravity 比重 1.2Kg/L 1.2公斤/公升

Intended Uses

用途适用于钢结构防腐面漆，尤其适用于由于健康和安全原因不允许加入溶剂时。

Suited for painting steel structure as anti-corrosive finish,r, especially for the conditions where it is not permitted to use

Solvent due to health and safety.

Product Information 产品简介单组份水性面漆,不燃，对经良好的处理的钢材表面具有极优异的附着力，良好的防腐性，干性快，能用漆乳化漆，醇酸漆，水性环氧漆及氯化橡胶覆涂。浅黄色、蓝色、绿色、白色、灰色、红棕色等

One component water based finish, Excellent adhesion to varous old coat. Good anticorrosive property, fast dry. May overcoat with emulsion coating, alkyd paint, water based epoxy paints and chlorinated rubber paints Light-yellow, yellow, blue, green, white, gray, red-brown etc.

Application details 产品数据V olume Solids 固体份About 35% 约35% Dry Flm Thickness干膜厚度50-75microns 50-75微米Theoretical Coverage 理论涂布率

5.9m2 /Kg at 50um dry film thickness

5.9平方米/公斤,以50微米干膜厚计Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗

Storage and Handling 施工详述Mix Radio 混合比One package 单罐装

Method of Application 施工方法

Airless Spray 无空气喷涂 Recommended 推荐采用

Brush or Roller 涂刷或辊涂 Recommended 推荐采用

Conventional Spray 传统喷涂 Suitable, but diluting is necessary

适用但需稀释

Thinner 稀释剂 Water,Maximum thining is 5% 自来水，最大稀释量5% Cleaner 油漆设备清洗剂 Water and specific cleaner 自来水和专用清洗剂

Pot Life 使用期 Not limit 没限制

Storage 贮存期 One year 一年

Drying time

干燥时间

Substrate

Temperature底材温

度

Touch Dry

表干

（min）

Hard Dry

硬干

（H）

Over coating Interval

覆涂间隔

Mix最短Max最长

35℃

25℃

≤15

≤30

≤20

≤24

2hours小时

4ours小时

Not limit

没限制水性丙烯酸面漆的用途和使用说明

Specification and Surface preparation 技术要求及表面处理Right preceding coat such as water based acrylic primer: The surface is clean and dry. The sub strate temperature should be more than 5℃, at least 3℃ above the dew point, and the relative humidity is less than 70% when the paint being applied and its curing. Please stir still to even before application. The temperature of the paint should be greater than 15℃,If not, must thin it with clean water to the specific viscosity, but if thining beyond the limitation, the sag resistance would be reduced.参

适合的前涂层，如水性丙烯酸底漆，干净无污物，底材温度在施工和固化时至少5℃且至少高于露点3℃，相对湿度不高于70%

用前请充分搅拌均匀，油漆温度高于15℃，否则需加适量清洁自来水稀释以达到施工所需粘度，但稀释过多会导致抗流挂降低。

Safety Precautions 安全措施This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product. Although this paint product is relatively harmless, minimal safety precautions, as follow, should be done in order to avoid danger or accident:

This paint is based on water. In general, this paint has no danger of explosion. However, enough ventilation is necessary at application site.

Because the paint liquid is harmful, protect skin and eyes, and avoid touching with paints( Recommended to wear working clothes, gloves, eye protection, face masks, barrier creams and so on). If paint gets in touch with skin. Wash fully with a large amount of fresh water and soap or application commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately. Recommended face guard with ventilation pipe for the sake of no absorption of paint fog and volatile harmful gas especially in bad condition.

Handle empty containers with care and do not bring about environmental contamination. NOTICE: If consumers have not taken effective safety precautions(Refer to the specfications), our company will NOTbe responsible for any accident.

本产品由专业人缘在工业场所使用,使用时请参照本说明书及健康安全手册,如客户在使用本产品前,未能仔细了解有关产品的健康安全知识,请与本公司联系.

该涂料为相对无害涂料，为避免事故或危害发生，应采取最低限度的安全措施如下：

该涂料为水性漆，一般情况下无燃烧和爆炸危险，但应适当通风已改善涂装环境。

因漆液并非无害，所以仍应采取有效措施以防止皮肤和眼睛与涂料接触(如使用工作服,手套,护目镜,面罩及涂防护油等)如产品不慎接触到皮肤,应用温水及肥皂或适当的工业清洁剂彻底清洗,如眼睛受到污染,用清水冲洗至少10分钟,并立即就医.

建议佩戴通风面罩以避免吸入漆雾和有害溶剂气体,尤其在通风不良环境下施工时,细心处理旧漆桶以免污染环境.

责任声明: 对于未按本公司要求采取有效安全措施儿引起的安全事故,本公司不负任何责任.

来源：纽克莱官网：